This site uses cookies. To find out more, see our Cookies Policy

Electrical Calibration Technician in Florham Park, NJ at Synerfac

Date Posted: 4/1/2019

Job Snapshot

Job Description

Responsibilities:

•Will inspect, diagnose, and repair, electronic products using a variety of test equipment to diagnose and make repairs under the direction of the supervisor.
•Complete and maintain accurate service records both electronically and manually.
•Responsible for asset pass/fail inspection, cleaning and conducting electrical safety check of the products.
•Remove and replace faulty, defective, and broken parts.
•Isolate faulty circuits, defective module and parts with latent damage.
•Help with intermittent and unknown phenomena.
•Demonstrate the ability to maintain acceptable levels of quality and productivity as acquired through technical training and demonstrated aptitude within a designated skill set and company policies and procedures to complete assigned tasks.
•Understand and accept the responsibility to ensure the safety of all company products that are repaired, by following established processes and procedures.
•Maintain a clean, well-organized work environment, maintain acceptable standards for attendance and punctuality.
•Work required overtime as needed.
•Perform other related duties as assigned.

  Job Requirements  

Requirements:

•An Associate's Degree in Electronics/Computer Major or a minimum of 2 years of equivalent training in this field is required.
•Must have sufficient manual dexterity with small hand tools.
•Must have experience or ability to work with test equipment such as oscilloscopes, multimeters, pattern generators.
•The ability to read and follow manuals, work instructions, job standards, and related information is necessary.
•Must be customer focused/oriented.

Hours: M-F 7-3:30

Jen Andresen
Synerfac Technical Staffing
Phone: 973-299-9920
Fax: 973-299-9942
jandresen@synerfac.com